Training Videos
CNC Router Table Tool Library Set-up by Vectric
A quick look at the tool library set-up for your Router Table with Vectric Software.
Setting your Vacuum Pump Accessories by FPZ
This video explains how to install accessories and set motor protection.
Determining your Vacuum Pumps voltage by FPZ
This video shows how to wire a three phase blower for high or low voltage.
Setting the safety valve on your Vacuum Pump by FPZ
This video shows how to properly set the pressure relief valve for a vacuum.
Feeds and Speeds for your Router Bits By LMT Onsrud
This video shows how to properly calculated your Chip Load.
How to Calibrate your Bits in the ATC
This video shows how to properly calibrate your Bit Height.
How to Set Z Zero
This video shows how to properly Reset your Bit Height to make smaller adjustments.
Using The Tool Calibration tool to Reset your Carousal tool holder
This video shows how to properly use the Rental Calibration Tool to reset all your tool holders.
Let's Talk
What Can We Do To Help You Get To The Next Level
Get in Touch: